Southern Ski Tools

(803)556-4949 /

Toe Jam Spreader

"It'll Get your Toes Out of a Jam!"


We all have customers who come in complaining that their ski boot is too narrow or they need just a bit more room for their first or fifth met. The TJS Basic tool is used for stretching for width to get you out of a JAM. The unit has a medial,and lateral die, both approximating the thickness of the foot. The entire tool is made of steel rather than aluminum. Because of this distinct design the steel will not absorb the heat as fast which means that your boot won't have to be heated as much. The heat you apply doesn't readily get absorbed by the tool.

So what do you do for the customer who is fitting a bit too short for length in their ski boots? The Lengthening Beam will get you out of that JAM. By combining the TJS Basic with the Lengthening Beam you are able to independently stretch just the big toe of the ski boot. The die used with the Lengthening beam is called the Big Hal, as it will stretch just for the hallux. If the customer has a rigid hallux this tool is a must buy.

The The Ultimate Cuff Stretcher has quickly become a leg saver for those customers who have calves that are larger than what the ski boot manufacturer designed their boots around. This ski boot stretching tool is designed to stretch a PAIR of ski boots at the same time. The Ultimate Cuff Stretcher is the fastest way to stretch the cuff of a PAIR of ski boots. Simply place the boots in the jig, heat the back of the spine of the boot on both sides of the dies and start turning the adjustment arm and the boots now fit that customer that was complaining about the ski boots hurting their calves. It is also a fantastic tool to help realign a customer that is being pushed too far forward because of the forward lean built into the boot.

Do you have a customer with a large bunion? Remove the medial die from the TJS Basic and install the Bunion Popper. A must for those hard to accommodate feet.

The Instep Jack is a shortened version of the TJS Basic while using a square base plate and one cuff die. This is the easiest to use tool available for stretching the instep of a ski boot. Oh how you can stop the complaining of those customers that have high insteps.

 Toe Jam Spreader Tool Set


#1. Toe Jam Spreader for width

#2. Lengthening Beam

#3. Bunion Popper

#4. 2 Cuff Die

#5 Instep Jack

It comes with a foam lined tool box.


Call for Pricing - (803)556-4949 Ask for Mike Tambling


or Email us at:


Toe Jam Spreader Warranty



WHAT IS COVERED:  All parts proven to be defective in materials or workmanship after factory inspection.


WHAT WE WILL DO:  Replace tool at no charge.  We reserve the right to substitute a tool of equal usefulness and value.


WHAT IS NOT COVERED:  Misuse, abuse, improper care or rust. Toolboxes are not warranted.


WHAT PURCHASER MUST DO:  Return tool prepaid and INSURED to: Southern Ski Tools, 1671 Lake Murray Blvd., Columbia, South Carolina 29212 Attn: Customer Service/Repairs.  Please include your name and street address.  Your tool will be returned to you prepaid.


In no event shall Southern Ski Tools be liable for general incidental or consequential damages including, without limitation, injury or damage to persons or property, arising out of any defect in this tool, or arising out of any breach of the warranty made herein.  Some states do not allow limitations on how long an implied warranty will last or the exclusion or limitation of incidental or consequential damage, so the above limitations or exclusions may not apply to you since this warranty give you specific legal rights and you may also have other rights which vary from State to State.

   1671 Lake Murray Blvd, Columbia SC 29210  -